Hotpoint SR09PFWAX Instrucciones de uso descargar pdf (Pagina 23)

GB

23

Grill

Remove the grill pan and the wire grid food support. It is best to wash these items immediately after use to

prevent stains from being burnt on when used again. Wipe out the Grill compartment, use a fine steel wool

soap pad to remove stubborn stains from the grill runners and the floor of the compartment. Wipe over the

control panel with a damp cloth and polish with a dry cloth.

Control Panel

Do not use Do not use

Do not use cream cleaners, oven cleaners or aerosols, scouring pads or abrasive powder for cleaning the

plastic knobs as damage will occur.

Decorative Trims

It is advisable to clean the decorative trims regularly to prevent any build up of soiling. The recommended

method of cleaning is to wipe over the trims with a soft cloth wrung out in warm water or mild non-abrasive

cleaner. (If in doubt try the cleaner on a small area of trim which is not noticeable in normal use). Then, after

wiping with a cloth wrung out in clear water, dry with a soft clean cloth.

Doors

Wipe over the outer door glass panels with a cloth wrung out in warm soapy water, then after wiping with a

cloth wrung out in clear water, dry with a soft clean cloth.

Ensure that glass doors are not subjected to anyEnsure that glass doors are not subjected to any

Ensure that glass doors are not subjected to any

sharp mechanical blows.sharp mechanical blows.

sharp mechanical blows.

Glass Inner Door Panel (where fitted) Glass Inner Door Panel (where fitted)

Glass Inner Door Panel (where fitted) – open the door fully and unscrew the two screws securing the glass

panel, taking care not to allow the glass to fall. The glass panel may now be washed at the sink. Stubborn

stains can be removed by using a fine steel wool soap pad.

Ensure the glass panel is not subjected toEnsure the glass panel is not subjected to

Ensure the glass panel is not subjected to

any sharp mechanical blows. any sharp mechanical blows.

any sharp mechanical blows. Take particular care not to damage the inner surface which is coated with a

heat reflective layer. After cleaning, rinse and dry with a soft cloth. For slight soiling the inner glass panel may

be cleaned, while still warm, without removing it from the door.

Warning: Oven must not be operated with inner door glass removed.

Take care Take care

Take care during cleaning not to damage or distort the door seals. Do not lift the door seal from the oven

chassis, if necessary remove the seal by carefully unhooking the corner clips.

Take care Take care

Take care that the rating label edges are not lifted during cleaning, and furthermore that the lettering is not

blurred or removed.

Ovens

Remove the rod shelves and grill pan. Use a fine steel wool soap pad to remove stubborn stains from the rod

shelves, grill pan and the floor of the oven.

Clean the glass part of the oven door using a sponge and a non-

abrasive cleaning product, then dry thoroughly with a soft cloth. Do not use rough abrasive material or sharp

metal scrapers as these could scratch the surface and cause the glass to crack.

Oven Shelf

Supports

The shelf supports are removable and dishwasher safe.

To remove To remove

To remove hold the support at the front and pull away from the oven side, this can then be cleaned in a sink

or a dishwasher. When removed it allows access to the oven side, which can be cleaned with warm soapy

water.

To refit To refit

To refit the support, insert the longer leg into the rear fixing hole and push in the front leg.

Oven Lamp

Replacement

Open the oven door and remove the rod shelves. Using a suitable cloth to protect the fingers grip the light

glass dome, unscrew anti-clockwise and lift. Reach into the aperture with fingers, and unscrew the lamp

anticlockwise. Fit replacement lamp (25W 300°C rated SES), refit dome.

WARNING: To avoid electric shocks - please ensure that the electricity supply to the appliance isWARNING: To avoid electric shocks - please ensure that the electricity supply to the appliance is

WARNING: To avoid electric shocks - please ensure that the electricity supply to the appliance is

switched off and the appliance is fully cold, before removing the lamp lens.switched off and the appliance is fully cold, before removing the lamp lens.

switched off and the appliance is fully cold, before removing the lamp lens.

Care and cleaning