Hotpoint HOB 611 S Instrucciones de uso descargar pdf (Pagina 4)

ELECTRICAL CONNECTION

Electrical connection must be made before connecting the

appliance to the electricity supply. The appliance must be

installed by a qualified technician who is fully aware of current

safety and installation regulations. Specifically, installation must be

carried out in compliance with the regulations of the local

electricity supply company. Make sure that the voltage indicated

on the rating plate corresponds to the voltage in your home.

Regulations require that the appliance is earthed: use conductors

(including the earth conductor) of the appropriate size only. The

manufacturer declines all liability for injury to persons or animals

and for damage to property resulting from failure to observe the

above regulations. For the electrical connection use a HO5 RR-F

type cable as indicated in the table below:

Power supply voltage.

The appliance must be connected to the electricity supply

by means of an all-pole disconnect switch with minimum

contact gap of 3 mm.

Warning

: the power supply cable must be long enough to allow

the cooktop to be removed from the worktop and must be

positioned so as to avoid damage or overheating caused by

contact with the base.

Terminal block connections

Note

: the yellow/green earth wire must be connected to the

terminal with the symbol and must be longer than the other

wires.

• Strip approx. 70 mm of the cable sheath from the power

supply cable (

• Strip approx. 10 mm of sheath from the wires. First insert the

cable through the opening in the cover. Then insert the power

supply cable into the cable clamp and connect the wires to the

terminal block as indicated in the diagram printed on the

bottom of the cooktop.

• Secure the power supply cable (

) by means of the cable

clamp.

• Fit and secure the protective cover (

) which is screwed to

the lower face of the cooktop.

After the electrical connection, fit the hob from the top and hook

it to the support springs, according to the illustration.

Conductors Amount x size

230 V ~

3 X 2.5 mm

230 V 3 + ~

4 X 1.5 mm

400 V 3N + ~

5 X 1.5 mm

400 V 2N + ~

4 X 1.5 mm

6gb60031.fm5 Page 14 Wednesday, November 28, 2001 6:22 PM

1 2 3 4 5 6 7

Comentarios a estos manuales

Sin comentarios

Hotpoint HOB 611 S Instrucciones de uso Pagina 4

Comentarios a estos manuales

Relacionado con productos y manuales para No Hotpoint HOB 611 S