Hotpoint AKR 045/IX Instrucciones de uso descargar pdf (Pagina 3)

Electrical Connection

•

The installer is responsible for the correct electrical connection of

the appliance and the observance of the relative safety

prescriptions.

•

The appliance must be connected to the mains, checking first of all

that the voltage corresponds to the value given on the rating plate

and that the section of the electrical wires can take the load

indicated on the rating plate.

•

Fit a standard plug which is suitable for the power absorbed by the

appliance.

•

Plug in the appliance into an earthed socket.

•

Do not use multiple plug adapters or extension cables.

•

The connection can be made directly to the mains by means of an

all-pole disconnect switch with minimum contact gap of 3 mm.

•

When the appliance is installed, the switch or socket must always

be accessible.

•

The supply cable must not come in contact with hot parts and must

be positioned so that it does not exceed the temperature of 75°C at

any point.

•

After the appliance has been installed, the electrical components

must be inaccessible.

No liability for damage or injury to persons or property will be accepted

from the non-observance of these requirements.

IF THE HOB SURFACE IS CRACKED DISCONNECT THE APPLIANCE FROM THE

mains. Connection TO A GOOD EARTH WIRING SYSTEM IS ABSOLUTELY

ESSENTIAL. THE MANUFACTURER ACCEPTS NO RESPONSIBILITY FOR ANY

INCONVENIENCE CAUSED BY FAILURE TO COMPLY WITH THIS RULE.

For UK only

This appliance can be connected directly to the mains, using fixed

wiring via a Double Pole Switched Fused Spur Outlet (13 amps. fuse).

As the colours of the wires in the mains lead of the appliance may not

correspond with the coloured markings identifying the terminal in our

spur box, proceed as follows:

- The green and yellow wire must be connected to the

terminal marked E (Earth) or ( ) coloured Green.

- The blue wire must be connected to the terminal

marked N (Neutral), or coloured Black.

- The brown wire must be connected to the terminal

marked L (Live) or coloured Red.

Replacing the supply cable

• Turn the cooktop upside down and unhook the terminal board

cover inserting a screwdriver into the two hooks (A).

• Open the strain release (cable clamp) unscrewing screw (F),

unscrew the clamps screws and remove the cable.

Connect the new supply cable, of suitable size and section, to the

terminal board, following the diagrams below:

Use cables type H05RR-F

The diameter of the supply cable must not exceed 9 mm.

230 V~ 50/60 Hz

3x1 mm

or 3x1.5 mm

230 V

3gb66018.fm Page 11 Monday, August 26, 2002 3:34 PM

1 2 3 4 5

Comentarios a estos manuales

Sin comentarios

Hotpoint AKR 045/IX Instrucciones de uso Pagina 3

Comentarios a estos manuales

Relacionado con productos y manuales para No Hotpoint AKR 045/IX