Hotpoint AKP 802 IX Instrucciones de uso descargar pdf (Pagina 6)

CARE AND CLEANING

Important: Do not use steam cleaners.

Exterior of the oven

• Clean with a damp cloth. If it is very dirty, add a few drops of washing

up detergent to the water. Wipe with a dry cloth.

• Do not use corrosive or abrasive detergents, which dull the surface.

In the event that one of these products comes into contact with the

oven, immediately clean it using a damp cloth.

• Slight differences in colour on the front of the appliance are

determined by the different materials used, such as glass, plastic and

metal.

Accessories

• Soak the accessories in water with washing up detergent

immediately after use. Food residues can be easily removed using a

brush or sponge.

Oven cavity

• Do not use abrasive cleaners or pan scourers. Use special oven

cleaners and follow the manufacturer's instructions.

• After every use, wait for the oven to cool then clean it to prevent the

build-up of baked-on food residues.

• With long cooking times or when cooking on different levels,

especially food with a high water content (pizzas, stuffed vegetables,

etc.) condensation may form on the inside of the doors and the seal.

When the ovens are cool, dry the inside of the doors with a cloth or

sponge.

• Clean the glass of the doors with a suitable liquid detergent.

Replacing the bulb

Warning: Disconnect the appliance from the power supply.

To remove the side runner frame, push it simultaneously down and

towards the centre of the oven (A-fig.1). Then lift the side runner frame

upwards to release it from the cavity wall (B-fig.1).

Prise off the glass cover C using a screwdriver E.

Change the lamp D (fig. 2).

Note: use only 25 W/230 V, E-14 type, T300°C bulbs available

from After Sales Service.

Refit the glass cover, pressing it slightly (fig. 2).

To refit the side runner frame, follow the steps above in reverse order.

Removing the oven doors (for cleaning)

To facilitate cleaning, the oven door can be removed as follows:

Hinges F are provided with two movable bolts G.

When bolt G is raised, the hinge is released from its housing. Having

done this, the door must be lifted upwards and removed, sliding it

outwards; hold the sides of the door near the hinges when performing

these operations.

To refit the door, insert the hinges into their seats and open the door

fully.

Remember to rotate the two movable bolts G used to hook the two

hinges before closing the door (fig. 3).

WARNING

• Take care not to dislodge the hinge lock system when

removing the door as the hinge mechanism has a strong

spring system!

• Do not immerse the door in water at any time.

Fig. 2

Fig. 3

Fig. 1

1 2 3 4 5 6 7

Comentarios a estos manuales

Sin comentarios

Hotpoint AKP 802 IX Instrucciones de uso Pagina 6

Comentarios a estos manuales

Relacionado con productos y manuales para No Hotpoint AKP 802 IX

Powiązane produkty i podręczniki dla Systemy kina domowego Pioneer SE-MJ551T