Hotpoint GQ64ST Manual de usuario descargar pdf (Pagina 8)

560 mm.

45 mm.

When installing the hob above a built-in oven without forced

ventilation, ensure that there are air inlets and outlets for ventilating

the interior of the cabinet adequately.

Gas Connection for the Hob

The hob should be connected to the gas supply by an authorized

installer. During installation of this product it is essential to fit an

approved gas tap to isolate the supply from the appliance for the

convenience of any subsequent removal or servicing. Connection

of the appliance to the gas mains or liquid gas tanks must be

carried out according to the safety standards currently in force,

and only after it is ascertained that it is suitable for the type of

gas to be used. If not, follow the instructions indicated in the

section entitled, “Adapting the Hob for Different Types of Gas”. If

the hob is to be connected to tanks containing liquid gas, use

pressure regulators that comply with current safety standards.

Important: To insure that the appliance operates safety, the gas

is regulated correctly and your appliance lasts over time, make

sure that gas pressure levels comply with the indications given

in Table 1, “Nozzle and Burner Specifications”.

Gas Connection to Non-flexible Pipe

(copper or steel)

Connection to the gas source must be done in such a way as to

not create any stress points at any part of the appliance.

The appliance is fitted with an adjustable, "L" shaped connector

and a gasket for the attachment to the gas supply. Should this

connector have to be turned, the gasket must be replaced

(supplied with the appliance).

The gas feed connector to the appliance is a threaded, male 1/

2" connector for round gas pipe.

Gas Connection to Flexible Steel Pipe

The gas feed connector to the appliance is a threaded, male 1/2"

connector for round gas pipe. Only use pipes, tubes and gaskets

that comply with current safety codes. The maximum length of

the flexible pipes must not exceed 2000 mm. Once the connection

has been made, ensure that the flexible metal tube does not

touch any moving parts and is not crushed.

555

475

Before fastening the cooktop in place, position the seal

(supplied) along the perimeter of the countertop, as

shown in the figure.

Fastening Clamps - Assembly Diagram

Clamp Position for Clamp Position for

H=20mm top H=30mm top

Front

Clamp Position for

H=40mm top Back

N.B: Use the clamps contained in the "accessory kit."

f) In the event the hob is not installed above a built-in oven, a

wood panel must be inserted as insulation. This panel must

be placed at least 20 mm from the bottom of the hob itself.

Important: When installing the hob above a built-in oven, the

oven should be placed on two wooden strips; in the case of a

joining cabinet surface, remember to leave a space of at least 45

x 560 mm at the back.

Installation

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Comentarios a estos manuales

Sin comentarios

Hotpoint GQ64ST Manual de usuario Pagina 8

Comentarios a estos manuales

Relacionado con productos y manuales para Placas Hotpoint GQ64ST