Hotpoint SW8 AM2C KAR Guía de uso y cuidado Pagina 9

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 12
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 8
EN
9
Use & Care guide
TROUBLESHOOTING
What to do if... Possible reasons Solutions
The appliance doesn’t
work.
There may be an appliance power
supply problem.
Make sure:
there is not a power failure;
the plug is properly inserted in the power socket and the
double-pole switch (if present) is in the correct position
(on);
the household electrical system protection devices
function;
the power cable is not broken;
The inside light does not
work.
It may be necessary to replace the
light bulb.
Disconnect the appliance from the power supply and contact
the Technical Assistance Service if you need a replacement.
The internal
temperature of the
compartments is not
cold enough.
The reasons could vary (see
“Solution”) column.
Check that:
the doors are closed properly;
the appliance is not installed near a heat source;
the temperature is appropriately set;
the circulation of air through the ventilation grilles on the
base of the appliance is not obstructed.
There is water on
the bottom of
the refrigerator
compartment.
The defrost water drain is blocked. Clean the defrosting water drain (see section “Cleaning and
Maintenance").
The front edge of the
appliance that the door
gaskets seal against is
hot.
This is not a problem. It prevents
condensation from forming.
A solution is not needed.
The temperature
of the refrigerator
compartment is too
cold.
The set temperature is too
cold.
Try to set a less cold temperature.
Turn o the fan (if present) described in the paragraph
“FAN”.
Vista de pagina 8
1 2 3 4 5 6 7 8 9 10 11 12

Comentarios a estos manuales

Sin comentarios